鹏珝膜应用方案推荐
时间:
2025-04-14
针对PVC耐磨层厚度0.07-0.7mm,同时带防增塑剂迁移，防止水性地板胶烂胶，结构设计如下：
1.针对PVC耐磨层厚度0.07-0.7mm，结构设计如下：
| 1层 One-layer | PVC耐磨层0.07-0.7mm PVC Wear-resisting surface 0.07-0.7mm |
| 2层 Two-layer | PVC彩膜 PVC color film |
| 3层 Three-layer | 防翘膜9S、防翘膜12S、防翘膜19S（推荐产品） Anti-warp film 9S, Anti-warp film 12S, Anti-warp film 19S(Recommended product) |
| 4层 Four-layer | PVC中层料，比重2.0左右，无需低比重底料来做平衡，降低综合成本。 PVC intermediate material, the specific gravity is about 2.0, there is no need for low specific gravity base material to balance and reduce the comprehensive cost. |
2.针对PVC耐磨层厚度0.07-0.7mm,同时带防增塑剂迁移，防止水性地板胶烂胶，结构设计如下：
| 1层 One-layer | PVC耐磨层0.07-0.7mm PVC Wear-resisting surface 0.07-0.7mm |
| 2层 Two-layer | PVC彩膜 PVC color film |
| 3层 Three-layer | 防翘膜9S、防翘膜12S、防翘膜19S（推荐产品） Anti-warp film 9S, Anti-warp film 12S, Anti-warp film 19S(Recommended product) |
| 4层 Four-layer | PVC中层料，比重2.0左右，对中料物性要求较低，降低综合成本。 PVC intermediate material, the specific gravity is about 2.0, there is no need for low specific gravity base material to balance and reduce the comprehensive cost. |
| 5层 Five-layer | 托底膜6D、托底膜9D Bottom support film 6D, Bottom support film9D |
3.适合LVT在线复合、无需UV表面处理，防烟烫的耐磨层，结构设计如下：
| 1层 One-layer | 耐磨层1918（推荐产品） Wear-resisting surface 1918(Recommended product) |
| 2层 Two-layer | PVC彩膜 PVC color film |
| 3层 Three-layer | PVC中层料，比重2.0左右，无需低比重底料来做平衡，降低综合成本。 PVC intermediate material, the specific gravity is about 2.0, there is no need for low specific gravity base material to balance and reduce the comprehensive cost. |
更多新闻
想了解更多产品信息？请给我们留言